JSON-LD markup generated by Google Structured Data Markup Helper.

Honda

Home / Honda

We Service and Repair all Honda cars

  • 2005 Honda Element

    Honda Element
    Mileage
    278,516
    Service Date
    10/14/2024
    Services Performed
    • FOUND STARTER JUST CLICKED, CHECK CHARGING SYSTEM IS AT 14.5 VOLTS, BATTERY IS GOOD. NEEDS STARTER
    • REPLACED BAD STARTER AND TESTED CHARGING SYSTEM ALL OK
     
    TRAVIS S. gave our service a 5 star review on 10/14/2024
  • 2018 Honda Accord

    Honda Accord
    Mileage
    55,850
    Service Date
    10/10/2024
    Services Performed
    • VALVE CLEARANCE – ADJUST – [Adjust only if noisy.] BRAKE HOSES & LINES – INSPECT – [Check the master cylinder and ABS/VSA modulator-control unit for damage and leakage.] DRIVESHAFT/PROPELLER SHAFT DUST BOOTS – INSPECT – [Check boots for cracks and boot bands for tightness.] EXHAUST SYSTEM – INSPECT – [Check catalytic converter heat shields, exhaust pipes, and muffler for damage, leaks, and tightness. NOTE: According to state and federal regulations, failure to do this maintenance item will not void the customer's emissions warranties. However, Honda recommends that all maintenance services be done at the recommended interval, to ensure long-term reliability.] FLUID & LUBRICANT LEVELS – INSPECT FRONT BRAKE SYSTEM – INSPECT – [Check pads and discs for wear (thickness), damage, and cracks. Check calipers for damage, leaks, and tightness of mounting bolts.] FUEL LINES & CONNECTIONS – INSPECT – [Check for loose connections, cracks, and deterioration; retighten loose connections and replace damaged parts. NOTE: According to state and federal regulations, failure to do this maintenance item will not void the customer's emissions warranties. However, Honda recommends that all maintenance services be done at the recommended interval, to ensure long-term reliability.] PARKING BRAKE – INSPECT REAR BRAKE SYSTEM – INSPECT – [Check pads and discs for wear (thickness), damage, and cracks. Check calipers for damage, leaks, and tightness of mounting bolts.] STEERING GEAR/RACK – INSPECT – [Check steering linkage. Check fluid lines for damage or leaks.] STEERING RACK BOOTS – INSPECT – [Check boots for damage and leaking grease. Check fluid lines for damage or leaks.] SUSPENSION COMPONENTS – INSPECT – [Check bolts for tightness. Check condition of ball joint boots for deterioration and damage] TIE ROD ENDS – INSPECT ENGINE OIL – REPLACE ENGINE OIL FILTER – REPLACE MAINTENANCE MINDER LIGHT – RESET – [Reset the Maintenance Minder Light after every service is performed. If the Light is reset without performing a service, the system will not show the proper maintenance intervals. This can lead to serious mechanical problems because you will no longer have an accurate record of when maintenance is needed.]
    • INDICATOR – SERVICE B MAINTENANCE @SERVICE B – w/o Valve Adjustment
    • VALVE CLEARANCE – ADJUST – [Adjust only if noisy.] MAINTENANCE MINDER LIGHT – RESET – [Reset the Maintenance Minder Light after every service is performed. If the Light is reset without performing a service, the system will not show the proper maintenance intervals. This can lead to serious mechanical problems because you will no longer have an accurate record of when maintenance is needed.] TIRES – ROTATE
    • VALVE CLEARANCE – ADJUST – [Adjust only if noisy.] MAINTENANCE MINDER LIGHT – RESET – [Reset the Maintenance Minder Light after every service is performed. If the Light is reset without performing a service, the system will not show the proper maintenance intervals. This can lead to serious mechanical problems because you will no longer have an accurate record of when maintenance is needed.] TRANSMISSION FLUID – REPLACE – [Driving in mountainous areas at very low vehicle speeds results in higher transmission temperatures. This requires transmission fluid changes more frequently than recommended by the Maintenance Minder. If you regularly drive your vehicle under these conditions, have the transmission fluid changed every 25,000 miles (40,000 km).]
    • INDICATOR – SERVICE 03 MAINTENANCE @SERVICE 03 – 1.5L Eng,Gas,Automatic CVT Trans – w/o Valve Adjustment
     
    THERESE P. gave our service a 5 star review on 10/10/2024
  • 2013 Honda Civic

    Honda Civic
    Mileage
    72,334
    Service Date
    10/8/2024
    Services Performed
    • STATER FAILED LOADING TEST
    • CHECK BRAKE LIGHTS
    • STARTER ASSEMBLY – Remove & Replace – EX,HF,LX
     
    CHRISTINE W. gave our service a 5 star review on 10/8/2024
  • 2020 Honda CR-V

    Honda CR-V
    Mileage
    35,406
    Service Date
    9/16/2024
    Services Performed
    • REPAIR TIRE
     
    CAROL s. gave our service a 5 star review on 9/18/2024
  • 2009 Honda CR-V

    Honda CR-V
    Mileage
    150,886
    Service Date
    8/15/2024
    Services Performed
    • REPLACE REAR PADS AND ROTORS
     
    BETH Z. gave our service a 5 star review on 8/17/2024
  • 2018 Honda HR-V

    Honda HR-V
    Mileage
    83,277
    Service Date
    7/26/2024
    Services Performed
    • Remove wheels from vehicle. Inspect brakes. Computer spin balance. Reinstall wheels to vehicle and torque lug nuts to manufacturer's specifications.
     
    Martin S. gave our service a 5 star review on 7/26/2024
  • 2012 Honda Accord

    Honda Accord
    Mileage
    87,252
    Service Date
    7/16/2024
    Services Performed
    • VALVE CLEARANCE – ADJUST – [Adjust only if noisy.] MAINTENANCE MINDER LIGHT – RESET – [Reset the Maintenance Minder Light after every service is performed. If the Light is reset without performing a service, the system will not show the proper maintenance intervals. This can lead to serious mechanical problems because you will no longer have an accurate record of when maintenance is needed.] TIRES – ROTATE
    • INDICATOR – SERVICE 01 MAINTENANCE @SERVICE 01 – w/o Valve Adjustment
    • VALVE CLEARANCE – ADJUST – [Adjust only if noisy.] AUTOMATIC TRANSAXLE FLUID – INSPECT BRAKE FLUID LEVEL – INSPECT BRAKE HOSES & LINES – INSPECT – [Check the master cylinder and VSA modulator-control unit for damage and leakage.] CLUTCH FLUID – INSPECT DRIVESHAFT/PROPELLER SHAFT DUST BOOTS – INSPECT – [Check boots for cracks and boot bands for tightness.] ENGINE COOLANT – INSPECT – [Check the coolant level in the coolant reservoir. Make sure it is between the MAX mark (A) and the MIN mark. If the coolant level in the coolant reservoir is at or below the MIN mark, add coolant to bring it up to the MAX mark, then inspect the cooling system for leaks.] EXHAUST SYSTEM – INSPECT – [Check catalytic converter heat shields, exhaust pipes, and muffler for damage, leaks, and tightness. NOTE: According to state and federal regulations, failure to do this maintenance item will not void the customer's emissions warranties. However, Honda recommends that all maintenance services be done at the recommended interval, to ensure long-term reliability.] FRONT BRAKE SYSTEM – INSPECT – [Check pads and discs for wear (thickness), damage, and cracks. Check calipers for damage, leaks, and tightness of mounting bolts.] FUEL LINES & CONNECTIONS – INSPECT – [Check for loose connections, cracks, and deterioration; retighten loose connections and replace damaged parts. NOTE: According to state and federal regulations, failure to do this maintenance item will not void the customer's emissions warranties. However, Honda recommends that all maintenance services be done at the recommended interval, to ensure long-term reliability.] MANUAL TRANSAXLE FLUID – INSPECT PARKING BRAKE – INSPECT – [Check the number of clicks (7 to 9) when the parking brake lever is pulled with 196 N (20 kgf, 44 lbf) of force.] POWER STEERING FLUID – INSPECT – [Check the reservoir at regular intervals, and add the recommended fluid as necessary. Always use Honda Power Steering Fluid. Using any other type of power steering fluid or automatic transmission fluid can cause increased wear, fluid leaks, and poor steering in cold weather. NOTE: If the fluid is contaminated, the screen in the reservoir may be partially blocked. Inspect the reservoir screen for any debris. If the reservoir screen is clogged, replace the reservoir, and check for the source of the contamination.] REAR BRAKE SYSTEM – INSPECT – [Check pads and discs for wear (thickness), damage, and cracks. Check calipers for damage, leaks, and tightness of mounting bolts.] STEERING GEAR/RACK – INSPECT – [Check steering linkage. Check fluid lines for damage or leaks.] STEERING RACK BOOTS – INSPECT – [Check boots for damage and leaking grease. Check fluid lines for damage or leaks.] SUSPENSION COMPONENTS – INSPECT – [Check bolts for tightness. Check condition of ball joint boots for deterioration and damage] TIE ROD ENDS – INSPECT WINDOW WASHER FLUID LEVEL – INSPECT ENGINE OIL – REPLACE ENGINE OIL FILTER – REPLACE MAINTENANCE MINDER LIGHT – RESET – [Reset the Maintenance Minder Light after every service is performed. If the Light is reset without performing a service, the system will not show the proper maintenance intervals. This can lead to serious mechanical problems because you will no longer have an accurate record of when maintenance is needed.]
    • front pads 8mm rear 6mm
    • EVAC SYSTEM AND FOUND LOW ON FREON. ADDED FREON AND PRESSURE SYSTEM. FOUND NOW LEAKS AT THIS TIME. FREON IS NOW FULL AND IS COOLING
     
    FRED H. gave our service a 5 star review on 7/16/2024
  • 2015 Honda Civic

    Honda Civic
    Mileage
    55,525
    Service Date
    5/31/2024
    Services Performed
    • SHOCK ABSORBER – Remove & Replace – Each Side
     
    TOBY G. gave our service a 5 star review on 6/3/2024
  • 2016 Honda Fit

    Honda Fit
    Mileage
    86,865
    Service Date
    5/23/2024
    Services Performed
    • REPLACED BOTH HEADLIGHT ASSBY
    • FRONT PADS 10 MM NEEDS TO HAVE ROTORS RESURFACE. REAR BRAKES 3.5 MM CLEANED AND ADJUSTED.
    • Remove wheels from vehicle. Inspect brakes. Computer spin balance. Reinstall wheels to vehicle and torque lug nuts to manufacturer's specifications. IF SENSOR HAVE TO BE PROGRAMMED LABOR IS SUBJECT TO CHANGE
    • ALIGNMENT
    • NEEDS TO REMOVED DASH UNIT AND REPAIR WIRING AT CONNECTOR
     
    JOHN R. gave our service a 5 star review on 5/27/2024
  • 2004 Honda CR-V

    Honda CR-V
    Mileage
    110,427
    Service Date
    5/16/2024
    Services Performed
    • VALVE COVER GASKET – Remove & Replace
    • REPLACE FRONT PADS AND OR REPLACE OR RESURFACE ROTORS
    • VALVE COVER WAS THE CAUSE
    • SET TIRE PSI, TOP FLUIDS. CHECK TIRE TREAD AND CHECK TPMS REPORT TO OFFICE IF TIRES NEED TO BE ROTATED
    • Remove wheels from vehicle. Inspect brakes. Computer spin balance. Reinstall wheels to vehicle and torque lug nuts to manufacturer's specifications.
     
    BARBARA A. gave our service a 5 star review on 5/18/2024